The Palisades V2 is something EarthQuaker Devices said they would never do… an overdrive based on the legendary TS808! Gasp! The horror! Another tubescreamer?? Really?? Yes, but as with everything EQD, things are always pushed to the next sonic level. You’re not just getting a Tubescreamer. You’re getting ALL the Tubescreamers and then some in this behemoth of an overdrive that’ll give you everything from a comforting classic crunch to frantic fire-breathing walls of fuzz.
With 6 different clipping voices, 5 bandwidth settings and 2 gain channels you will be hard-pressed to not find a setting that will wipe every midboosting overdrive off your board. The clipping voices determine how transparent and open or tight and crunchy the distortion is. They will vary drastically depending on where the gain is set, what channel is active and how much bandwidth is being used. The bandwidth sets the frequency response of the distortion and goes from thin, light and clean through fat heavy and crunchy. It may very well be the single most important control the Palisades has and what really sets it apart.
Gain A is a lower gain channel with a wider range of grit that is great for strumming open chords. Gain B is a higher gain channel with a tighter range that is great for palm muting and/or shredding solos. The Palisades also has a foot switchable volume boost with adjustable level to take it over the top when you want to throw your foot up on the monitor and rip your sweet leads…or maybe just push the front end of your amp a little harder. Not enough? How about a normal/bright switch to mix and match the overall tone to different amps and guitars? Still not enough? OK then, how about a buffer on/off switch to tighten up the tone and make it sparkle when set to “ON” or warm it up and make it sag when set to “OFF”. The Palisades is a versatile dude that will give you years of loving companionship. Each Palisades is hand made one at a time in the tiny tree house community of Akron, Ohio.